Conveyor Belt

Rubber conveyor belt of cold seamless connectivity

Rubber conveyor belt of cold seamless connectivity 
 
Multi-layer rubber conveyor belt of cold seamless connectivity

Abstract The fixed conveyor belt of cold seamless multi-layer, according to the use of rubber conveyor belt conveyor belt of the intensity of choice to seamlessly connect the length of the cold, as well as the determination of the direction of overlap.
Key words multi-layer rubber conveyor belt cold seamless connection
Countries of the world mining industry, as well as port terminals, a large set of transport of the stations were able to see as Rubber Conveyor Belt  the main means of transport of the rubber conveyor belt, which is why rubber
Rubber conveyor belt connected to become a major issue.
Rubber conveyor belt is divided into multi-layer, steel wire, pvc and other types, while the rubber conveyor belt of cold seamless connection only minor changes to adapt to multi-layer and a fixed length of rubber transmission
Send band, not suited to the mining industry face retractable rubber conveyor belt connection, the multi-layer rubber conveyor belt of cold seamless connection technology is the result of long-term practice of the German TIP TOR and summarized in.
A multi-layer rubber conveyor belt of cold seamless connectivity
Multi-layer rubber conveyor belt lap of the schematic shown in Figure 1.
Figure 1 Schematic diagram of overlap
1.1 Connection to determine the length of
Multi-purpose rubber conveyor rubber belt  conveyor belt manufacturer  according to the different layers of different options, if the lap length is the length of select waste materials, while the lap part of the short will
There is not enough bearing strength, or tear caused by the conveyor belt accident. Multi-layer rubber conveyor belt lap length and the intensity Acid Alkali Resistant Conveyor Belt of the selected related
Its calculation formula is as follows:
(1) 1! Additional lap size (joint length) Table 1.
(2) the width of the tape! 0.3 tilt cutting (about 16 “).
For example: conveyor belt width of 1000mm nominal strength 630/4750mm (lap use, see table) +300 mm (left oblique) = 105 (0 required tape length) left oblique Cutting shown in Figure 2.
Figure 2 Schematic diagram of the first layer of material under oblique woven fabric layer of 30mm Cutting tape ends when a 90-draw “of the CB baseline (see Figure 2) according to tape width! 0.3 = approximately 16″ draw oblique lines.
Table 1 Multi-rubber conveyor belt cold seamless connection method reference value of this size only at one end of the tape measure and a line of demarcation. Sometimes we need to cut down the multi-part conveyor intermediate, and then connect it up.
1.2 to replace a damaged tape
(1) conveyor belt on the release of tension, and tension with the tensioning device to tape together. In the two tensioning device marked oblique side of the middle and cut tape.
(2) to be replaced tape segment cut off parallel to the bevel edge (tape was on the shelf shore in advance).
(3) The calculation of the length of overlap. Before and after the connection to connect some length (see table)! 2 + is replaced by the length of the segment of the tape + tape width! 0.3 oblique segment.